chinomango2022-03-26 05:39:35

harbor的找不到了,而且质量差,嘴尖断过。最好是头部嘴是尖的因此是卡在3/8或1/2的轴上,开销带两孔但是<1mm。要不给个建议,例如钢丝穿过去使劲拉?或者梯形改锥插入增大缝隙?

xia232022-03-26 14:02:24
How about this Craftsman?
chinomango2022-03-27 03:14:11
thanks I found a similar one